SGD $725,095
Seller Information
View Seller InformationGENERAL EQUIPMENT & SUPPLIES INC
Contact:Dean Stalheim
Phone:+1 605-215-0268
Fargo, North Dakota, USA 58103
General
Year
2023
Manufacturer
SUPERIOR
Model
F62033HBS
Serial Number
2275500
Condition
New
Stock Number
E00069147
Description
SUPERIOR 6203 GUARDIAN® HORIZONTAL SCREEN TWIN 36" SCREWS PORTABLE WASH PLANT EQUIPPED PER THE BELOW:
- 6203 GUARDIAN 3 DECK SCREEN WITH RH DRIVE
- 24" FEED BOX WITH 1/4AR LINERS
- SIDE TENSIONED DECKS (3) SET FOR 5FT PANELS
- COIL SPRINGS
- 40HP 1200RPM SCREEN DRIVE MOTOR
- SUPERIOR TWIN 36X25' FINE MATERIAL WASHER
- (2) 15HP MOTORS WITH DOGE SHAFT MOUNT REDUCERS
- CAST WEAR SHOES
- 200TPH RATING
PLANT SPECIFICATIONS:
- CONSTRUCTION - MAIN FRAME CONSTRUCTED OF WIDE FLANGE STRUCTURAL BEAMS
- DISCHARGE CHUTE - MANUAL ROLLAWAY CHUTE CONSTRUCTED OF 1/4" STRUCTURAL STEEL
WITH 1/4" WELD-IN AR 400 LINER
- RUBBER FLASHING - NOT INCLUDED
- BLENDING CAPABILITY - 1/4 PANEL BLENDING GATES IN DISCHARGE CHUTE SYSTEM
- TOP DECK DISCHARGE - OVER THE KINGPIN OR BLENDS DOWN TO MIDDLE DECK CROSS
CONVEYOR
- MIDDLE DECK DISCHARGE - TO MIDDLE DECK CROSS CONVEYOR OR BLEND DOWN TO BOTTOM
DECK CROSS CONVEYOR
- BOTTOM DECK DISCHARGE - TO BOTTOM DECK CROSS CONVEYOR OR BLEND UP TO MIDDLE D
D DECK CROSS CONVEYOR
- WALKWAY - WALKWAY AROUND BOTH SIDES AND FEED END OF SCREEN: EXTENDS OUT TO
THE END OF DISCHARGE CHUTE FOR SAFE ACCESS
- OBSERVATION PLATFORM - NOT INCLUDED
- WALKWAY ACCESS - ACCESS TO BOTH SIDES OF CHASSIS WITH (2) FOLDING STEEP ANGLE
STAIRS
- ACCESS GATES - 2) SELF CLOSING HINGED GATES AT ALL WALKWAY ACCESS POINTS
- SLURRY HOPPER - SCREEN FEED SLURRY HOPPER FOLDS HYDRAULICALLY FOR TRANSPORT
WITH (2) 2.5" WATER LINES
- WYE STRAINER - BOLT-ON WYE STRAINER FOR FRESH WATER SUPPLY TO PREVENT DEBRIS
FROM ENTERING WASH SYSTEM
- TOOL BOX - 48" X 12" X 16" ALUMINUM TOOL BOX
- SAFETY TIE OFF - OVERHEAD SAFETY TIE OFF POSTS WITH CABLE BETWEEN TWO POSTS
- PAINT - STANDARD SUPERIOR PAINT - GRAPHITE GRAY (RAL 7024) WITH SAFETY YELLOW
GUARDING AND HANDRAIL
- GUARDING - FOR ALL DRIVE AND TAIL PULLEYS, GUARDS MAY NOT MEET ALL LOCAL
CODES; CUSTOMER IS RESPONSIBLE TO HAVE GUARDING INSPECTED
CHASSIS SPECIFICATIONS:
- AXLE - TRIDEM AXLE WITH (12) 11RX22.5 RADIAL TIRES
- SUSPENSION - SPRING SUSPENSION
- BRAKES - COMPLETE AIR BRAKE PACKAGE
- FIFTH WHEEL - INCLUDED
- LIGHTS - BRAKE AND DIRECTIONAL SIGNALS
- MUD FLAPS - INSTALLED BEHIND TRANSPORT WHEELS
- CRIBBING LEGS - (6) FIXED STRUCTURAL STEEL CRIBBING LEGS
- LANDING GEAR - (4) HYDRAULIC LIFT-ONLY LEVELING LEGS WITH 9 HP HONDA POWER
UNIT
SPRAY SYSTEM AND UNDERFLUME:
- UNDERFLUME CONSTRUCTION - 1/4" AR PLATE
- UNDERFLUME SPRAY BARS - LOCATED AT FEED AND DISCHARGE POINTS
- MANIFOLD - 8" BOLT FLANGE FOR FRESH WATER HOOKUP (CUSTOMER RESPONSIBLE FOR -
FRESH WATER PLUMBING TO MANIFOLD)
- MANIFOLD DISTRIBUTION - DISTRIBUTES WATER TO SCREEN SPRAY BARS, SLURRY HOPPER,
FMW WASH BACK AND FINES HOPPER
CROSS CONVEYOR SPECIFICATIONS:
- CROSS CONVEYORS - (2) 30" X 12' LONG SLIDE-IN REVERSING CROSS CONVEYORS
- DRIVE - CLASS I HEAD END
- GEAR REDUCER - DODGE SHAFT MOUNT
- MOTOR - 7.5 HP MOTOR(S) TEFC
- DRIVE PULLEY - 10" DIAMETER, DIAMOND LAGGED CEMA CROWN FACED DRUM
- TAIL PULLEY - 10" DIAMETER CEMA WING PULLEY
- BEARINGS - DODGE
- IDLERS - CEMA C, 5" DIA. ROLLS, SEALED FOR LIFE BALL BEARINGS, 20°
- BELTING - 3 PLY 3/16 X 1/16 330 PIW
- BELT SPLICE - FACTORY VULCANIZED BELT SPLICE(S)
- BELT SCRAPER - (1) EXTERRA PRIMARY SCRAPER PER CROSS CONVEYOR
- GUARDING - WE DO NOT WARRANT THAT MANUFACTURERS' GUARDING WILL MEET ALL LOCAL
CODES. IT IS THE RESPONSIBILITY OF THE END USER TO HAVE GUARDING CHECKED BY A
LOCAL INSPECTOR, PRIOR TO STARTUP OF EQUIPMENT OPERATIONS, CORRECTIVE ACTIONS
AND ASSOCIATED EXPENSE ARE THE RESPONSIBILITY OF THE END USER.