2017 CATERPILLAR D6N WH

2017

CATERPILLAR

D6N WH

8,305

Used

4937

D9676

Idle Hours: 4,937, Neutral Hours: 5,593, Load Factor: 23%, CAT C7.1 ACERT Engine, Powershift/Autoshift Transmission, Cab (ROPS) with A/C, Differential Steer, 6 Way PAT Blade with Trash Rack, SALT Undercarriage, NEW CAT 33" Trapezoidal Shoes, Air Turbine Engine Pre-Cleaner, Factory Waste Handling (Landfill) Arrangement,Rear Striker Bar Box Assembly, Final Drive Seal Guards, Heated & Cooled Seat, Heavy Duty Rad Guards, Heavy Duty Bottom Pans, Fuel Tank Guard, High Speed Oil Change, Cold Weather Arrangement, Heavy Duty Track Guiding Guards, Rated at 182 HP, Weight 45,000 LBS. Repair/Condition Report: The following are repairs completed by the CAT Dealer prior to Marcel Equipment owning the machine; At 755 hours, performed 500 hour service At 680 hours, installed NEW steering control sensor At 1,147 hours, calibrated implement valve At 1,937 hours, performed 2,000 hour service At 2,231 hours, performed service At 2,858 hours, performed service At 3,113 hours, performed service At 4,338 hours, performed service At 4,700 hours, performed service At 4,880 hours, performed service At 3,113 hours, performed service At 4,880 hours, performed service At 4,967 hours, installed NEW EGR valve At 5,089 hours, performed service At 5,528 hours, performed 250 hour service At 5,769 hours, performed service At 6,003 hours, performed service At 6,140 hours, installed NEW a/c condenser fans At 6,164 hours, installed NEW fuel transfer pump At 6,299 hours, performed service At 6,373 hours, REBUILT right final drive At 6,572 hours, performed 250 hour service At 6,898 hours, performed service At 7,015 hours, resealed left final drive At 7,621 hours, installed NEW transmission cooler At 7,621 hours, installed NEW rad assembly At 8,283 hours, performed 2,000 hour service At 8,283 hours, installed UPDATED ECM software At 8,283 hours, installed NEW seat belt At 8,283 hours, installed NEW front wiper motor & arm At 8,283 hours, installed NEW fan assembly At 8,284 hours, installed NEW batteries Marcel Equipment completed the following inspections; Upon arrival, machine was fully stripped for power washing Full visual & operational inspections were completed Engine, torque, transmission & hydraulic pressures were taken to ensure within OEM spec Performance checks were completed Oils were checked for contaminates Magnets & suction screens were checked for contaminates All filters were cut open & inspected for contaminates Machine was serviced as required Engine & transmission were changed Marcel Equipment then completed the following repairs: Installed NEW pilot accumulator Installed NEW c-frame bearings Installed NEW lift cylinder pins & bearings Installed NEW rear wiper motor Installed NEW angle cylinder pins & bearings Installed all NEW hydraulic lines for blade cylinders Line bored blade bores as required Resealed starter Installed all NEW lines for implement valve Installed NEW powertrain lines as required Serviced batteries & connections Serviced & cleaned complete HVAC system Completed all required cab repairs Completed all required cosmetic repairs Machine is now scheduled to be sand blasted & painted.

Enclosed