2012 CATERPILLAR D8T

2012

CATERPILLAR

D8T

6,615

Used

2075

D5523

CAT C15 ACERT Engine, Engine Block Heater, Powershift Transmission, Cab (ROPS) with A/C, Differential Steer, Fuel Tank Guards, 24" Extreme Service Track Shoes, CAT Angle Blade with Twin Tilt - 180" Wide, CAT SU Blade is Available, Carco H140 Winch & Fairleads, Rear Screen, CAT SS or MS Ripper is Available, High Speed Oil Change, Accugrade Ready, Flood Light Arrangement, Rear View Camera, Oil Samples Available, Rated at 364 HP, Weight 82,000 LBS. Repair/Condition Report: The following are repairs completed by the CAT Dealer prior to Marcel Equipment owning the machine; At 1,925 hours, installed NEW DPF filter At 2,228 hours, installed NEW a/c evaporator At 3,029 hours, installed NEW ARD head At 3,214 hours, resealed transmission pump & installed NEW u-joints At 3,214 hours, resealed implement pump At 3,908 hours, installed NEW segments, idlers, rollers & track chains At 6,601 hours, installed NEW a/c condenser, dryer & accumulator At 6,685 hours, performed 1,000 hour service When unit arrived in yard, MEL had local CAT dealer complete the following: Strip machine for power washing CAT TA inspection Update ECM flash files Cut open all filters & inspect for contaminates - all clean Service emissions system if needed (filters, dof, spark plug, injector, etc) Service engine Inspect magnetic plugs/screens & suction screens - all clean Check oil levels Inspect oils for discolouration Checked for logged & active codes & repair Check for applicable service letters Completed the following pressure checks to ensure within OEM spec; Engine high & low idle rpm Engine high & low idle oil pressures Fuel pressure Full stall boost Full stall speed Transmission pump pressure Transmission lube pressure - low/high Transmission clutch pressures Torque inlet pressure Torque outlet pressure Torque convertor stall speed Torque convertor lock-up clutch Flywheel low pressure - low/high Implement stand-by pressure Margin pressure High pressure cut-off Pilot pressure Accumulator pressures Steering charge pressure Brake pressure Steering high pressure cut-off Hoist relief pressure Brake cut-in/cut-out pressure Fan pressures, speeds & calibration Based on inspection, CAT mechanic completed the following repairs; Installed NEW ARD head spark plug Completed 5,000 hour emission service Field cleaned DPF filter Completed engine valve set & injector set Resealed valve cover Resealed exhaust manifold & installed NEW studs Resealed engine oil pan Installed NEW track cannon seal on left side Replaced all required hoses/lines Tested & serviced batteries & connections Completed required cab repairs Completed miscellaneous repairs on machine Greased machine Machine is now ready to go to work!

37,194.57 kg

Enclosed

271.43 kW