USD $1,200,000
常规
年限
2022
制造商
TEREX FINLAY
型号
I140RS
序列号
TRX140RST0MN37718
状况
新建
库存号
E00060943
描述
FINLAY I-140RS TRACKED IMPACTOR PLANT EQUIPPED AS PER BELOW:
ENGINE:
- TIER 4 FINAL: SCANIA DC13 368KW (500HP) ENGINE
IMPACT CHAMBER:
- TEREX CR032 IMPACT CHAMBER
- FULLY HYDRAULICALLY ASSISTED APRON SETTING AND HYDRAULIC APRON RELEASE
- MANUAL RAISE CHAMBER FLAP ALLOWING EXTRA INLET CLEARANCE
- 4 BAR ROTOR - TOOL STEEL BLOW BARS 2 HIGH & 2 LOW
- DIRECT DRIVE VIA CLUTCH
- DRIVE BELT TENSIONER WHEEL
- BLOW BAR LIFTING TOOL SUPPLIED
- TIP SPEED RANGE 35-44 M/SEC (115-144FT./SEC)
- SMALLER DRIVE PULLEY FITTED TO GIVE A ROTOR TIP SPEED RANGE OF 31-39M/SEC
(102-128FT./SEC) STANDARD LARGE PULLEY STILL DISPATCHED WITH MACHINE
- HYDRAULIC RAISE OF CHAMBER INLET FLAP
- ROTOR FITTE WITH (2) FULL MATENSITIC CERAMIC & 2 LOW MARTENSITIC BLOW BARS
HOPPER & FEEDER:
- VGF FIXED HOPPER
- STEPPED GRIZZLY FEEDER WITH INTEGRAL PRE-SCREEN, STANDARD 50MM SPACING
- MESH APERTURE ON GRIZZLY FEEDER: 38MM (1.50")
- SELECTABLE DISCHARGE TO BY-PASS CONVEYOR OR MAIN CONVEYOR
- BLANKING MAT FOR VGF
- PRE-SCREEN TOP DECK FITTED WITH SIDE TENSIONED MESH, 30MM APERTURE STANDARD
- INDEPENDENT PRE-SCREEN C/W HYDRAULICALLY FOLDING AND LOCKING HOPPER AND
BLANKING MAT, 50MM CASSETTE SPACING * 38MM MESH AS STANDARD
- INDPENDENT PRE-SCREEN HOPPER EXTENSIONS
- PRE-SCREEN PUNCH PLATE OPTIONAL SPACING - 25MM/50MM/75MM - NEED TO SPECIFY
MAIN CONVEYOR:
- 1300MM (51") BELT FULL LENGTH
- PIPED FOR OVERBAND MAGNET
- HYDRAULIC RAISE/LOWER FOR MAGNET
- UNDER CRUSHER VIBRATORY FEEDER WITH WEAR RESISTANT STEEL LINERS (C/W SHORTENED
MAIN CONVEYOR)
AUXILARY:
- BYPASS CONVEYOR WITH 80MM WIDE PLAIN BELT, DISCHARGING TO THE RHS OF THE
MACHINE
- TWIN POLE OVERBAN MAGNET C/W STAINLESS STEEL SKIRTING & STAINLESS STEEL
DISCHARGE CHUTE, DISCHARGING RHS OF THE MACHINE
RS COMPONENTS:
- 4.88M X 1.52M (16' X 5') SINGLE DECK AFTER SCREEN C/W 40MM MESH AS STANDARD
UNLESS OTHERWISE STATED
- 500MM (20") WIDE BELT TRANSFER CONVEYOR
- 500MM (20") WIDE BELT HYDRAULIC FOLDING RE-CIRCULATING CONVEYOR ABLE TO SLEW
FOR STOCKPILING OVERSIZE MATERIAL
- 1400MM (55") WIDE BELT FINES CONVEYOR
- RAPID DETACH AFTER SCREEN SYSTEM FOR FLEXIBILITY
- BELT WEIGHER BELT SCALE
CLIMCATE SPEC:
- STANDARD OILS (RECOMMENDED FOR AMBIENT TEMPERATURES BETWEE -5 TO +30 DEG. C
DUST SUPPRESSION:
- PIPED FOR DUST SUPPRESSION C/W SPRAY BARS
- WATER PUMP NOT INCLUDED
ELECTRICAL:
- EMERGENCY STOPS
- HAND HELD TRACK CONTROL SET WITH CONNECTION LEAD
- RADIO REMOTE SYSTEM: OPERATIONAL CONTROLS OF MACHIN (AUTO START/STOP) & TRACK
MOVEMENT
- PRESSURISED AIR SYSTEM FOR ELECTRICAL CONTROL CABINET
GENERAL:
- SAFETY GUARDS IN COMPLIANCE WITH MACHINERY DIRECTIVE
- AUXILIARY DRIVE