2018 CATERPILLAR D6T XL WH

2018

CATERPILLAR

D6T XL WH

7,665

中古

2044

D4687

CAT C9.3 ACERT Engine, Engine Block Heater, Powershift Transmission, Cab (ROPS) with A/C, Differential Steer, Engine Air Pre-Cleaner, Cab Air Pre-Cleaner, Waste Handling (Landfill) Arrangement, SALT Undercarriage, 24" Trapezoidal Track Shoes, Final Drive Seal Guards, SU Tilt Blade With Trash Rack, Automatic Reversing Fan, Rear Striker Bars & Box, Drawbar Counterweight, Fuel Tank Guards, Heavy Duty Bottom Guards, Rear View Camera, CAT Slope Indicate, Flood Light Arrangement, Front Pull Hook, Rated at 245 HP, Weight 58,000 LBS. Repair/Condition Report: The following are repairs completed by the CAT Dealer prior to Marcel Equipment owning the machine; At 1,812 hours, installed NEW parking brake solenoid At 2,531 hours, installed NEW fuel injectors At 4,986 hours, performed 5,000 hour emission service At 4,986 hours, completed valve set At 5,332 hours, installed NEW transmission pump At 5,332 hours, calibrated transmission & brakes At 5,332 hours, installed NEW powertrain ECM At 7,071 hours, installed NEW track groups When unit arrived in yard, MEL had local CAT dealer complete the following; Strip machine for power washing CAT TA inspection Update ECM flash files Cut open all filters & inspect for contaminates - all clean Service emission system if needed (filters, dpf, spark plug, injector, etc) Inspect magnetic plugs/screens & suction screens - all clean except transmission Serviced engine Check oil levels Inspect oils for discolouration Check for logged & active codes & repair Check for applicable service letters Completed the following pressure checks to ensure within OEM spec; Fan pressures & speed Engine rpm high & low idle Engine oil high & low idle pressure Fuel pressure Torque convertor stall speed Full stall boost Implement standby pressure Transmission pump pressure Torque inlet pressure Torque outlet pressure Torque convertor lock-up clutch Flywheel low pressure - high/low Transmission lube pressure - high/low Performed clutch fill calibration Steering system charge pressure Brake pressure Based on inspection, CAT mechanic completed the following repairs; Installed NEW ether start solenoid Diagnosed transmission issue, MEL repaired below MEL completed the following repairs: Removed transmission from unit & disassembled Found #1 reverse clutch discs failed - replaced discs & plates Found #3 clutch disc teeth worn - replaced discs All other discs & plates met reusability guidelines Installed NEW updated pistons from clutch #1 & #2 F&R Old pistons were cause of failure Installed updated retaining ring Installed NEW brass bushings on transmission shaft Resealed complete transmission Disassembled transmission pump for inspection Pump ok - replaced bushings & resealed Installed transmission & calibrated Verified clutch pressures - all within spec Verified powertrain pressures - all within spec Ran machine, removed screen - all clean Cut open transmission filter - all clean Cleaned out HVAC system Resealed starter motor Changed required hoses/lines Repaired condenser fan Removed final drive seal guards Cleaned, inspected & re-installed Tested batteries & serviced connections Cleaned engine pre-cleaner assembly Installed NEW track guide wear strips on front Completed required blade repairs Replaced required blade pins & bushings Line bored blade joints where required Greased machine Machine is now ready to work.

Enclosed