2012 CATERPILLAR D8T

2012

CATERPILLAR

D8T

4,380

中古

1301

D6020

CAT C15 ACERT Engine, Engine Block Heater, Powershift Transmission, Cab (ROPS) with A/C, Differential Steer, 24" Extreme Service Track Shoes, HDXL Undercarriage, CAT Angle Blade with Twin Tilt - 180" Wide, CAT SU Blade is Available, MS Ripper, HID Flood Light Arrangement, Automatic Reversing Fan, Rear View Camera, Rated at 364 HP, Weight 82,000 LBS. Repair/Condition Report: The following are repairs completed by the CAT Dealer prior to Marcel Equipment owning the machine; At 1,004 hours, installed NEW a/c evaporator core At 2,097 hours, installed NEW fuel pressure regulator & fuel transfer pump At 3,720 hours, converted System One undercarriage to SALT At 3,720 hours, installed NEW HDXL track groups, idlers & segments When unit arrived in yard, MEL had local CAT dealer complete the following; Strip machine for power washing CAT TA inspection Update ECM flash files Service emissions system if needed (filters, dpf, spark plug, injector, etc) Inspect magnetic plugs/screens & suction screens - all clean Serviced engine Check oil levels Inspect oils for discolouration Check for logged & active codes & repair Check for applicable service letters Completed the following pressure checks to ensure within OEM spec; Engine rpm high & low idle Engine oil high & low idle pressures Fuel pressure Full stall boost Full stall speed Transmission pump pressure Transmission lube pressure - high/low Transmission clutch pressures Torque inlet pressure Torque outlet pressure Torque convertor stall speed Torque convertor lock-up clutch Flywheel low pressure - high/low Implement stand-by pressure Margin pressure High pressure cut-off Pilot pressure Accumulator pressures Steering charge pressure Brake pressure Steering high pressure cut off Hoist relief pressure Brake cut-in/cut-out pressure Fan pressures,speeds & calibration Based on inspection, CAT mechanic completed the following repairs; Installed NEW ARD head spark plug Completed ASH service regen Field cleaned DPF filter Installed REMAN injector in #2 cylinder Resealed exhaust manifold & installed NEW studs Completed engine valve set & injector set Resealed valve cover Installed NEW lower rad hoses Installed NEW transmission filter hoses Installed NEW lower torque convertor hoses Resealed engine oil pan Resealed blade lift cylinders Resealed implement pump & flow compensators Installed NEW battery cable Tested & serviced batteries & connections Replaced all required hoses/lines Completed required cab repairs Completed misc repairs on machine Greased machine Machine is now ready to go to work.

37,194.57 kg

Enclosed

271.43 kW