2018 TEREX FINLAY I140

2018

TEREX FINLAY

I140

TRX140ICJOMI57043

Bekas

E00063956

USED FINLAY I-140 EQUIPPED AS PER BELOW: ENGINE: TIER 4 FINAL /STAGE IV : SCANIA DC13 373KW (500HP) ENGINE IMPACT CHAMBER: - TEREX CR032 IMPACT CHAMBER - FULLY HYDRAULICALLY ASSISTED APRON SETTING AND HYDRAULIC APRON RELEASE - MANUAL RAISE CHAMBER FLAP ALLOWING EXTRA INLET CLEARANCE - 4 BAR ROTOR - TOOL STEEL BLOW BARS 2 HIGH & 2 LOW - DIRECT DRIVE VIA CLUTCH - DRIVE BELT TENSIONER WHEEL - BLOW BAR LIFTING TOOL SUPPLIED - TIP SPEED RANGE 35-44 M/SEC (115-144 FT./SEC). - HYDRAULIC RAISE OF CHAMBER INLET FLAP - ROTOR FITTED WITH 2 FULL HIGH CHROME & 2 LOW MARTENSITIC BLOW BARS HOPPER AND FEEDER - VGF FIXED HOPPER - 2.5" ERIN FINGERS INSTALLED IN THE FIRST SECTION, 1.5" ERIN FINGERS IN THE SECOND SECTION, ERINS FINGERS ARE STEPPED DOWN - SELECTABLE DISCHARGE TO BY-PASS CONVEYOR OR MAIN CONVEYOR BLANKING MAT FOR VGF - INDEPENDENT PRE-SCREEN C/W HYDRAULICALLY FOLDING AND LOCKING HOPPER, AND BLANKING MAT. 50MM CASSETTE SPACING & 38MM MESH AS STANDARD. - INDEPENDENT PRE-SCREEN HOPPER EXTENSIONS MAIN CONVEYOR: - UNDER CRUSHER VIBRATORY FEEDER WITH WEAR RESISTANT STEEL LINERS (C/W SHORTENED MAIN CONVEYOR) - BELT WEIGHER ON MAIN CONVEYOR - ADDITIONAL DUST COVER AUXILIARY CONVEYORS: - PIPED FOR OVERHEAD BANDING - BYPASS CONVEYOR WITH 800MM WIDE PLAIN BELT, DISCHARGING TO THE RHS OF THE MACHINE. - TWIN POLE OVERBAND MAGNET C/W STAINLESS STEEL SKIRTING & STAINLESS - STEEL DISCHARGE CHUTE, DISCHARGING TO RHS OF THE MACHINE. CLIMATE SPEC: - STANDARD OILS - (RECOMMENDED FOR AMBIENT TEMPERATURES BETWEEN -5 TO +30°C) DUST SUPRESSION: - PIPED FOR DUST SUPPRESSION C/W SPRAY BARS ELECTRICAL: - EMERGENCY STOPS - HAND HELD TRACK CONTROL SET WITH CONNECTION LEAD - T-LINK TELEMETRY SYSTEM FITTED C/W 3 YEARS DATA SUBSCRIPTION - RADIO REMOTE SYSTEM - PRESSURIZED AIR SYSTEM FOR ELECTRICAL CONTROL CABINET - LIGHTING MAST GENERAL: - SAFETY GUARDS IN COMPLIANCE WITH MACHINERY DIRECTIVE - AUXILIARY DRIVE