2023 METSO C3054

2023

METSO

171

C3054

15993

Baru

Metso/Nordberg C3054 (30” x 54”) Jaw Plant Crusher: • Nordberg Model 3054 (30” x 54’) single toggle Jaw Crusher of non-welded • V-belts and motor sheave, drive guard, • 200 HP, 1200 RPM Motor • Hyd Adjust Feeder: • 54” x 20’ Grizzly Feeder • 40HP Motor • Feeder motor variable frequency speed drive • 3” nominal spacing, adjustable grizzly bars • V-belts, motor sheave, pivot motor base • Hopper constructed of 3/4” AR steel • Protective rubber curtain guards on both sides of feeder in loading areas Extended Rear Discharge Conveyor: • 60” Under crusher conveyor Extended (discharges over axles) • 20HP Motor • 3-ply belt with vulcanized splice • V-belt drive. • CEMA "C" 5" diameter troughing idlers. Rubber disc return idlers. • Impact bed – Superior MD Impact bed under crusher receiving hopper • Belt Scraper Chassis: • Four axle (Split Tandem) chassis constructed of heavy duty wide flange beam • Air Ride Suspension • Heavy duty 25,000lb suspension w/ (16) 11R x 22.5 radial tires • Brake Package – air brakes, emergency valve and plumbing • Light Package – brake and directional signals • Grizzly by pass chute from 1/4" A36 plate and 1/4" AR steel liners • 24” reversible cross conveyor w/ Dodge gearbox, 7.5 hp, CEMA C idlers, and 2-ply belt with vulcanized splice for Grizzly By Pass • Crusher discharge chute out of mild steel with AR liners • Crusher feed box out of ¾” Mild Steel with 1/2” AR400 liners • Lower operators platform and upper operators platform • Upper and lower access platforms with diamond plated catwalk, access ladder and railing • Bulkhead on one side of the plant • Qty (6) “Run On” hydraulic jacks • Qty (2) Swing down front legs with screw jacks • Chord holder • Aluminum tool box • Guarding – Appropriate guarding supplied. We do not warrant that our guards will meet all local codes. It is the responsibility of the end user to have them checked by a local inspector. Electrical: NEMA Switch Gear - Soft-start with a shorting contactor, branch breaker and lockout for a 200hp motor. Variable Speed drive, branch breaker and lockout for the feeder motor. Main breaker with a handle through the door. Control transformer with fusing. Reversing starter for 24” cross conveyor. (2) extra #2 starters for off plant conveyors. 100’ of lead cord to go to the power source