USD $18,027
Machine Location:3131 Hwy 7Toronto, Ontario, Kanada L4K 5E1(Opens in a new tab)
Informasi Penjual
View Seller Information
General
Tahun
2011
Produsen
CATERPILLAR
Model
259B3
Jam
6,069
Nomor Seri
YYZ02066
Kondisi
Bekas
Nomor Stok
MT37599B
Deskripsi
Equipment-certification-code: NCR
Inspection Information
GENERAL COMMENTS
GENERAL COMMENTS
Action
GENERAL COMMENTS Comments
Belts cracked Skid steer drifts to right when driving forward. Machine tracks have some good cuts in them and a nail stuck in them. Machine cab is compromised. Dented in multiple spots, cab drilled for aftermarket door that does not fit. Missing air vent
PREPARE MACHINE INSPECTION
CHECK PRODUCT LINK
N/A
CHECK WITH CUSTOMER FOR OPERATOR COMPLAINTS
N/A
DOWNLOAD MACHINE FAULT CODES
Normal
IS MACHINE EQUIPPED WITH PL?
N/A
IS PL ACTIVATED?
N/A
IS PL FUNCTIONING PROPERLY?
N/A
LISTEN FOR UNUSUAL NOISES
Monitor
OBSERVE ENGINE EXHAUST COLORS
Normal
PERFORM SAFETY/PREPARATORY INSPECTION
Normal
PREPARE THE MACHINE FOR THE INSPECTION
Monitor
LISTEN FOR UNUSUAL NOISES Comments
Start up sounds rough.
PREPARE THE MACHINE FOR THE INSPECTION Comments
Checked fluids before relocating.
LOWER-LEVEL INSPECTION
BOGIE AXLES (MTL)
Normal
BOGIE WHEELS (MTL)
Normal
CHAIN DRIVE (SSL)
N/A
DRIVE CHAIN TENSION (SSL)
N/A
IDLER AXLES (FRONT AND REAR) (MTL)
Normal
IDLER WHEELS (FRONT AND REAR) (MTL)
Normal
RUBBER TRACKS (MTL)
Monitor
SPROCKETS (MTL)
Normal
TIRES AND RIMS (SSL)
N/A
TRACK DRIVE FRAME AND/OR MACHINE FRAME (MTL/SSL)
Normal
TRACK DRIVES (MTL)
Monitor
TRACK TENSIONER (MTL)
Normal
RUBBER TRACKS (MTL) Comments
Few good cuts. Has nail stuck in it.
TRACK DRIVES (MTL) Comments
Skid steer drifts to right when driving forward.
MIDDLE LEVEL INSPECTION
AIR CLEANER ASSEMBLY
Normal
BATTERY AND BATTERY CABLES
Normal
BELTS, COMPRESSOR CLUTCH, AND PULLEYS
Monitor
CAB EXTERIOR
Action
CAB INTERIOR
Monitor
CYLINDER HEAD AND VALVE COVER
Monitor
ENGINE ACCESS DOOR
Monitor
ENGINE MOUNTS
Normal
ENGINE OIL PAN
Monitor
ENGINE WIRING HARNESS
Normal
EXHAUST MANIFOLD
Normal
FAN GUARD AND FAN
Normal
FUEL PRIMING PUMP, FUEL LINES, AND FUEL INJECTION PUMP
Normal
HORN AND/OR BACKUP ALARM
Monitor
HYDROSTATIC PUMP AND MOTOR COMPARTMENT (MUST TILT CAB FOR ACCESS)
Monitor
RADIATOR AND RADIATOR GUARD TILT MECHANISMS
Normal
RADIATOR CAP
Monitor
RADIATOR GUARD
Normal
RADIATOR HOSES AND OIL COOLER LINES
Normal
RADIATOR, OIL COOLER, CONDENSER
Monitor
STEPS AND HANDRAILS
Normal
TURBO CHARGER
Monitor
WATER PUMP
Normal
WORK LIGHTS
Normal
BELTS, COMPRESSOR CLUTCH, AND PULLEYS Comments
Belts cracked.
CAB EXTERIOR Comments
Machine cab is compromised. Dented in multiple spots, cab drilled for aftermarket door that does not fit.
CAB INTERIOR Comments
No wires seen for wind shield washer. Aftermarket door that doesn't fit. Missing air vent louvers.
CYLINDER HEAD AND VALVE COVER Comments
Oil residue around cylinder head.
ENGINE ACCESS DOOR Comments
Has a lot of play, very scratched and dented.
ENGINE OIL PAN Comments
Oil leak from around engine oil filter leaking down to your oil pan surroundings.
HORN AND/OR BACKUP ALARM Comments
Horn works, back up alarm not functional.
HYDROSTATIC PUMP AND MOTOR COMPARTMENT (MUST TILT CAB FOR ACCESS) Comments
Leaking hydraulic hose.
RADIATOR CAP Comments
No coolant visible upon taking coolant cap off.
RADIATOR GUARD Comments
Rust and paint chips.
RADIATOR, OIL COOLER, CONDENSER Comments
Radiator may be leaking, would have to inspect further.
TURBO CHARGER Comments
Turbo may be on its way out, blows blue smoke while warming up and more while under load. Would have to inspect further to confirm.
IMPLEMENTS/ATTACHMENTS
AREA AROUND LIFT ARMS
Monitor
BUCKET
Normal
BUCKET TIPS AND ADAPTERS
N/A
COUPLER
Normal
COUPLER CYLINDER
Normal
CUTTING EDGES
Normal
LIFT CYLINDER
Monitor
TILT CYLINDERS
Normal
LIFT CYLINDER Comments
Right side lift cylinder looks wet around the seal.
TILT CYLINDERS Comments
Left side has a dent. Pins are sloppy.
SITE CONDITIONS
AIR QUALITY
N/A
ALTITUDE
N/A
AMBIENT TEMPERATURE
N/A
HAUL ROAD CONDITION
N/A
HAUL ROAD GRADE
N/A
HUMIDITY
N/A
MACHINE UTILIZATION
N/A
MAINTENANCE PRACTICES
N/A
PRIMARY INDUSTRIES
N/A
UNDERFOOT CONDITIONS
N/A
WORKING MATERIAL
N/A
HYDRAULICS PERFORMANCE CHECKS
CYLINDER DRIFT TEST (MAXIMUM ALLOWABLE MOVEMENT AFTER 1 MINUTE)
Monitor
HYDRAULIC COUPLER SPEED TEST
Normal
LIFT CYLINDER SPEED TEST
Normal
OPERATION OF TWO SPEED FUNCTION TEST: MACHINE SPEED DECREASES WHEN FAST MODE IS DEACTIVATED
YES
OPERATION OF TWO SPEED FUNCTION TEST: MACHINE SPEED INCREASES WHEN FAST MODE IS ACTIVATED
YES
TILT CYLINDER SPEED TEST
Normal
TRACKING OF MACHINE (DRIFT) TEST (MAXIMUM ALLOWABLE DRIFT AFTER 30.5M (100FT) OF TRAVEL
Monitor
CYLINDER DRIFT TEST (MAXIMUM ALLOWABLE MOVEMENT AFTER 1 MINUTE) Comments
Cylinder has minor drift but it is not excessive
OPERATION OF TWO SPEED FUNCTION TEST: MACHINE SPEED INCREASES WHEN FAST MODE IS ACTIVATED Comments
Drifts right while moving forward. Exessive
TRACKING OF MACHINE (DRIFT) TEST (MAXIMUM ALLOWABLE DRIFT AFTER 30.5M (100FT) OF TRAVEL Comments
Drifts right while moving forward. Exessive