2022 SUPERIOR 6X20

2022

SUPERIOR

6X20

2008274

Baru

Superior 6x20 Three Deck Washplant over 36” Twin FMW Superior Guardian 6x20 Three Deck Horizontal Screen • 40HP Motor Fold up for Travel • 24” Feed box with AR Liners • Coil Springs • Side liners Superior Twin 36”x25’ Fine Material Washer • Qty2 15hp Motors at 20RPM screw speed • Up to 200TPH (subject to change based on final gradation) • Rubber Wear Shoes • Dodge Shaft Mount Gear Box Triple Axel chassis constructed of heavy duty wide flange beam • Heavy duty wide flange beam • Heavy duty spring suspension w/ (12) 11R x 22.5 radial tires • Brake Package – air brakes, emergency valve and plumbing • Light Package – brake and directional signals • Qty6 Cribbing Legs • Qty (4) Hyd landing legs with Honda engine • Diamond decked extended catwalk on three sides of screen with access ladder and railing • Vertical sliding ladders • Overhead Safety tie off • Tool box • Chord holder • Guarding – Appropriate guarding supplied. We do not warrant that our guards will meet all local codes. It is the responsibility of the end user to have them checked by a local inspector. • Chutes o Manual roll away screen discharge chutes 1/4" Mild Steel with 1/4" AR liners o All decks equipped with blending gates. Allows blending (in increments of 25%) o Under screen flume constructed of 1/4" AR to distribute to sand screw with two rinse bars Spray system • Manifold with 8” flange for freshwater hookup • Gate valves and plumbing • Galvanized spray bars and elbows, brass nozzles • Under screen flume to distribute to sand screw with two rinse bars • Slurry box over feed end of the screen w/two spray bars (Hydraulic Raise) • Gate valve supplied to balance water flow between left and right side of screw 30” Wide Cross Conveyors • Qty (2) 30”x12’ reversible cross conveyors • Dodge shaft mount gearboxes • Dodge bearings • 7 1/2 hp Motors • Cema B idlers • 3 ply belt • vulcanized splice • Exterra primary belt scraper Switchgear package NEMA enclosure Mounted on Skidded stand with lifting eyes and cord holders, NEMA components, breakers, Starters for all on plant motors, VFDs for twin sand screw, reversing starters for cross conveyors, start/stop pushbuttons, main disconnect, emergency stop, 2 extra #2 starters for 20 hp off plant motors, 100’ of lead wire