ROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rentROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rent
    ROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rentROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rent
    ROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rentROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rent
    ROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rentROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rent
    ROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rentROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rent
    ROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rentROCK SYSTEMS 110-LP New Conveyor / Feeder / Stacker Aggregate Equipment for rent
    Photos(6)

    ROCK SYSTEMS 110-LP

    Conveyor / Feeder / Stacker Aggregate Equipment
    Call for price 
    Rental Prices:
    Call For Availability

    Seller Information

    View Seller Information

    Rock Systems Inc

    Contact:Mike Bruce

    Sacramento, California, USA 95818

    Rental Contact Information

    Rock Systems Inc

    Contact:Mike Bruce

    Sacramento, California, USA 95818

    General

    Manufacturer
    ROCK SYSTEMS
    Model
    110-LP
    Condition
    New
    Description
    Rock Systems Low Profile Railcar Unloader. Rock Systems Semi-Portable Low Profile Railcar Unloader Model 110-LP complete as follows: a) Low profile railcar dump hopper 8’-0” long x 9’-8” wide x 5’-4” tall complete with adjustable skirtboards; removable grates; adjustable slide gate; track beams with holes drilled for 115-lb track and No. 62 rail clips. b) 48” wide discharge conveyor complete with Weg 50 h.p. electric motor, Dodge TAII6307H25 shaft mount reducer with internal backstop; v-belt drive and OSHA drive guard; 20” rubber lagged head pulley; 8” snub pulley; 12” self-cleaning tail pulley with screw take-up assemblies; Dodge SCM pillow block bearings; 3 ply conveyor belting with 3/16” x 1/16” rubber covers; CEMA “C” flat belt idlers mounted on close centers at load point followed by CEMA “C” 20o troughing idlers mounted on 4’ centers; CEMA “C” return idlers mounted on 10’ centers; vertical curve with hold down wheel; Flexco Rockline belt scraper; steel fabricated discharge hood with AR liners. c) Skid mounted, steel fabricated support structure with support leg. 2’ clearance under conveyor for maintenance. d) One rust inhibitor prime coat and one finish coat gray paint for all equipment; one finish coat safety yellow paint for all guarding. e) Electric motor control panel complete with 3 phase NEMA rated contactor at 460 volts with electronic overload relay, circuit breaker, 120 volt control power transformer, hand/off/auto selector switch, start push button, all mounted in a NEMA 3R enclosure.