USD $670,000
Machine Location:5633 Highway 13 W.Savage, Minnesota, USA 55378(Opens in a new tab)
Seller Information
View Seller InformationRoad Machinery & Supplies Co - Headquarters
Contact:Scott Kropiwka
Phone:+1 952-687-4800
Savage, Minnesota, USA 55378
General
Year
2021
Manufacturer
KPI-JCI
Model
CS3055
Serial Number
419726
Condition
Used
Stock Number
066300
Description
2021 KOLBERG PIONEER CS3055 JAW PLANT, ELECTRIC
PORTABLE
WITH VGF
Jaw Opening: 30 Jaw Width: 55
SPECIFICATIONS:
MAIN TRUCK - semi-trailer with triple rear axle,
fifth
wheel pin, rear crib leg and king pin support
assembly
TIRES - pneumatic - 12 rear 11:00 x 22.5 dual
mounted
AIR BRAKES on rear axles; travel light package
includes
mudflaps
PIONEER JAW CRUSHER - 3055 with hopper, hydraulic
wedge
type adjust with auto tension, with 2 HP
electric/hydraulic
power pack (LESS starter and wiring). NOTE: Set
jaw crusher
close side setting at 4" peak to peak unless
otherwise noted
END DELIVERY CONVEYOR - 48" channel frame with
drive, belt,
belt cleaner and 20 HP electric motor
VIBRATING FEEDER - 50" X 20' horizontal type oil
bath, with
5' replaceable and adjustable grizzly, 3/4" mild
steel deck
liner, supports, loading hopper fabricated of
3/4" plate,
v-belt drive and 40 HP electic motor,
4" nominal grizzly bar spacing is standard
BY-PASS CHUTE - under grizzly
SERVICE PLATFORM - with ladder
MOTOR MOUNT AND V-BELT DRIVE - for power unit
with safety
type v-belt guard
INCLUDED OPTIONS:
TEFC Electric Motor for crusher @ 1200 RPM 200
HP
Starter & 60' of cable for crusher motor 200HP
Electric Motor Controls - for basic plant
(excluding main
crusher) in NEMA-12 panel box with remote
panel board, includes variable frequency drive
for
feeder
Remote Cable - 150' remote cable vs. std.
Split Quad Airbag Suspension Axle with 16 11:00 x
22.5
Description
Amount
tires (in place of triple axle)
Hydraulic Raising and Plant Leveling System -
includes
power unit package consisting of an 8 HP gas
(electric start) with 11 gallon reservoir,
hydraulic
pump and control valves with relief valve mounted
on
rubber isolation mounts (for operating plant on
jacks
without cribbing) - 6 cylinders 6" run on style.
Hopper inside to be built using T1
Feeder pan deck liner to be 3/4" AR400
LESS flop gate
Rubber push block on rear
Pivoting jaw motor mounting on base
Rubber belting for feeder guard
Bypass chute to be 3/4" wear plate liner vs. 1/4"
Feeder to have spring in a spring on corners
Remote grease banks for plant
Modernized Jaw with Tramp Iron Relief (TIR)
System with 7
1/2 HP electric / hydraulic power pack with
HMI panel, including 50' of cable, for adjustment
control - LESS starter and wiring, in lieu of
wedge adjust.
(NOTE: Set jaw crusher close side setting with
TIR
cylinders fully retracted for shipment.)
Tramp Iron Relief control box to be mounted on
motor
control stand
Fenders on both sides
Radial tires vs. standard
100' of power cable with cord wraps (cable for
incoming
power)
Additional HMI Panel with 300' cable for TIR jaw
adjustment control